We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more
Xecuter LT Switch - V2 with LT clip
Latest LT Switch
Out of Stock - We can not accept orders at this time.
SKU
360LTSWITCH2
€16.95
| Switch for all the Liteon drives that enables firmware full read / write. For use with Liteon 74850 83850 93450. | |
 | |
| This kit has been designed with the beginner in mind. It has been in development for a while due to the absolute precision and stability needed to make sure it works for the lifetime of the DVD Drive with no soldering or glue for trace repairs. We have even included a built in continuity tester to make sure your trace cuts are perfect. Installation is simple. Make 3 trace cuts (The same as LT Switch v1.X), fit the LT Clip PCB to the Liteon PCB and use the continuity test button to make sure your cuts are correct (Green LED = Good, Red LED = bad). Once you have a Green LED you then fit the specially designed clip to fix the PCB in place. That's it! The LT Clip can be used with either the new LT Switch v2 or the CK3 Probe II. - If you are skilled and can solder then you can use the LT Switch v1.5 - If you are a multiple modder who can solder but wants to be fast and cost effective then you have the CK3 Probe II - If you are a beginner who has no soldering skills or equipment, does not want to buy or use conductive glue and does not want to expense to post their console to someone for modding - then the LT Clip solution is perfect for you. They have also included an On / OFF Led to show correct operation when switching to 0x72 vendor mode. It has been tested with the original DOSFLASH methods and also the new Jungle Flasher 0.1.69. All Liteon drive versions have been tested with 100% Success. There is no need to remove the LT Switch after it has been installed - simply switch to normal mode. | |
|
| Begagnad | No |
|---|---|
| Denna produkt har utgått ur sortimentet | Yes |
Write Your Own Review
